Application module: Additive manufacturing part and build information ISO/TS 10303-1835:2019(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definition
   4.3 ARM entity definitions
   4.4 ARM subtype constraint definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM entity definitions
     5.2.2 MIM rule definition

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Application module implementation and usage guide
G Change history
Bibliography
Index

Annex C
(informative)

ARM EXPRESS-G

The following diagrams provide a graphical representation of the ARM EXPRESS short listing defined in Clause 4. The diagrams are presented in EXPRESS-G.

This annex contain two distinct representations of the Application Reference Model of this application module:

NOTE  Both these representations are partial. The schema level representation does not present the ARM schema of modules that are indirectly imported. The entity level representation does not present the imported constructs that are not specialized or referred to by the constructs of the ARM schema of this application module.

The EXPRESS-G graphical notation is defined in ISO 10303-11.

Figure C.1 — ARM schema level EXPRESS-G diagram 1 of 1

Figure C.2 — ARM entity level EXPRESS-G diagram 1 of 3

Figure C.3 — ARM entity level EXPRESS-G diagram 2 of 3

Figure C.4 — ARM entity level EXPRESS-G diagram 3 of 3



© ISO 2019 — All rights reserved