Application module: Design specific assignment to interconnect usage view ISO/TS 10303-1663:2014-02(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARM
   4.2 ARM type definition
   4.3 ARM entity definitions
   4.4 ARM subtype constraint definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

EXPRESS specification:

*)
SCHEMA Design_specific_assignment_to_interconnect_usage_view_mim;

USE FROM Fabrication_joint_mim;    --  ISO/TS 10303-1668
(*

NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Fabrication_joint_mim ISO/TS 10303-1668

NOTE 2   See Annex D, Figure D.1 for a graphical representation of this schema.



*)
END_SCHEMA;  -- Design_specific_assignment_to_interconnect_usage_view_mim
(*


© ISO 2014 — All rights reserved